3 Tier Maypole Mirrored Effect Cupcake Stand

Arcylic 3 Tier Maypole Mirrored Effect Cupcake Stand 

Overall size: 300mm Wide * 212mm H

Tier 1: Dia 200mm (approx 6 inch)
Tier 2: Dia 250mm 
Tier 3: Dia 300mm

# 1st,2nd tier is 4mm thick, 3th tier is 5mm thick 
Each tier is 100mm apart and the total height of the stand is 212mm.
The acrylic comes wrapped in the manufactures protective covering 
No scratches or finger prints on the stand absolutely brand new.
The four small round plastic feet are included.They are used to level up the plate from the table to avoid uneccesary scratches.

This Cake Stand is Fully Adjustable, it will arrive to you flat packed in a box ready to be assembled. When putting it together you, you can put up as many tiers as you want, it does not need to be the full height if you do not wish.

Download Assembly instructions for Round Maypole cupcake Stand

PLEASE NOTE: You must remove the manufacturers’ thin layer of protective cover off the top of the mirror plates before assembling this product. Do not tear the white base as it will damage the mirror plate. Leave the white base as it is. The stand is not designed to move around once built so construct it in its final resting place. Do not attempt to move the stand once it has cakes on it.

ASSEMBLY GUIDE:

Parts: Mirror plates, head screws, double screws, acrylic rods and acrylic feet.

* Remove the protective cover from the top of the plate. The base of the mirror plate is white in color. Do not tear the white base as it will damage the mirror plates.
* Begin by placing the feet to the underside of the bottom plate ensuring they are evenly spaced. Acrylic feet are not adhesive so any mirror plate can be used as bottom tier.
* Take a metal head screw and place it on to a flat surface where the stand is to be constructed.
* Carefully line up the hole(s) of the largest plate with head screw ensuring the plate is resting securely on the acrylic feet.
* Now screw the first rod onto the screw thread of head screw making sure the mirror plate is clamped firmly between two acrylic rods.
* Continue by placing the next largest plate on to the screw thread of rod and tighten each mirror plate as you go.
* The final rod is to be used as the support for the final tier and the stand is completed by adding the other head screw into the top.

CARE GUIDE:

* The stand is made from acrylic which will scratch if it is not looked after properly. 
* To clean the product use warm water with a little washing-up liquid and soft cloth. 
* Do not use any abrasive cleaning products as they will make the acrylic. 
* Do not put the stand in a dishwater