5 Tier Step Mirrored Effect Cupcake Stand

5 Tier Mirrored Effect Step Cupcake Stand

The entire size:  
Length 350mm(13.8") * Width 350(13.8")* Height 421(16.6")mm

Tier 1: Dia 150mm, (5.9")
Tier 2: Dia 200mm, (7.9")
Tier 3: Dia 250mm, (9.8")
Tier 4: Dia 300mm, (11.8")
Tier 5: Dia 350mm, (13.8") 

There is no need for glue or other fixings.
The edges of the acrylic are perfectly clear and polished. Every part of the stand has been accurately cut and finished. 
Can be taken apart, washed and stored away for another time. 
The stand comes flat packed and only takes a few minutes to assemble.

This cupcake stand can hold approximately 60 cupcakes.We base our numbers on using a 50mm diameter cupcake.

# 1st,2nd,3rd,4th,5th is 4mm (0.2") thick.

Packaging: 
Flat packed in cardboard carton, each component is protected with bubble wrap.

Contents: 
Tier plates x 5
Supporting Pieces x 10
Arcylic Feet: 4

Below you will find the diagrams for each of our stands telling you exactly how we arranged the cakes on to each tier. 

Assembly Guide

* Remove the manufacturers’ protective cover of each component.
* Starting with the largest tier (the bottom one), place the acrylic dis on a clean flat surface, The stand is not designed to be moved around once built so construct in its final resting place. Do not attempt to move the stand once it has cakes on it.
* Take the 2 largest support pieces and fit them into the acrylic disc as shown. Please note these 2 pieces are slightly difference and will only fit together correctly in one way.
* Once the bottom layer is complete you can begin to add the following tiers on the top in the same way.

CARE GUIDE:

* The stand is made from acrylic which will scratch if it is not looked after properly. 
* To clean the product use warm water with a little washing-up liquid and soft cloth. 
* Do not use any abrasive cleaning products as they will make the acrylic. 
* Do not put the stand in a dishwater